Keor SPE must be used only in residential and commercial environments. The purpose of this manual is to provide the user with instructions for safely installing and using the Keor SPE battery cabinet, also
Once the battery cabinet is configured with UVR access, wait until the UPS outputs its rated UVR voltage, prior to turning on the circuit breaker. • UVR/Shunt Pin 1 = POSITIVE (+) Polarity
Read all instructions in the installation manual before installing or working on this product. Failure to follow these instructions will result in death or serious injury. Do not install the product until all
Installation or replacement of batteries must be located in a SERVICE ACCESS AREA: The service manual shall include the following instructions for battery replacement and disposal:
Because of the battery shunt trip wiring route in the UPS cabinet, the wiring from the Eaton Samsung Gen 3 to the UPS must use wire rated for 600V and Class 1 wiring methods.
Connect the battery cable accessory to one end of the battery port on the rear panel of the UPS and connect the other end to any battery port on the rear panel of the EBC.
FOR 480 VAC UPS APPLICATIONS, THE BATTERY CABINET IS WIRED DIRECTLY TO A 480 VAC SOURCE. FOR 208/220 VAC UPS APPLICATIONS, THE TOP WIRING KIT INCLUDES
Smaller UPS systems (e.g, up to 250 kVA) are commonly installed directly in the computer room along with their respective battery cabinets. The UPS and/or battery cabinets might be configured to look
Whether the Battery Cabinet is empty or partially assembled, it should be located, mounted and properly grounded prior to final assembly as instructed in this manual in sections 6.2.1, 6.2.2 and 6.2.3
This manual contains important instructions that should be followed during installation of your Liebert® EXM Battery Cabinet and accessories. Read this manual thoroughly, paying special attention to the
PDF version includes complete article with source references. Suitable for printing and offline reading.
